SG Home
Wellness

Exercise tutorial

Seated leg curl

The seated leg curl trains bending the knees against resistance, with the hamstrings at the back of the thighs doing much of the work. The backrest and thigh restraint support your position. Setting the pads matters because the lower-leg roller needs to move with your knees without dragging your hips forwards or pressing the restraint onto the kneecaps.

Watch a real demonstration

Insignia Series Seated Leg Curl

Demonstration by Life FitnessTraining

Loading the player connects to YouTube. Use its controls to play, pause or view full screen.

Version demonstrated: Life Fitness Insignia SS-SLC seated knee curl with thigh restraint and lower-leg roller.

Three things to notice

  • Locate the back pad, roller behind the lower legs and restraint over the thighs.
  • Follow the roller down and back as the knees bend.
  • Watch the roller return forwards while the thighs stay beneath the restraint.

Written tutorial by SG Home Wellness. Setup, finishing steps and modifications also draw on the supporting sources; the clip may not show each of these actions.

Before you move

Equipment Seated leg curl machine.

Also called Seated hamstring curl, Machine hamstring curl.

  • With the machine at rest, find the pivot: the point around which the roller arm turns. Adjust the back pad so the side of your knee lines up approximately with it. Sit fully on the seat with your back supported and your knees free to bend beyond the seat edge.
  • Set the lower-leg roller to support the lower leg at the ankle area as the machine’s placard shows. On this seated model it supports the back of the lower leg, not the front of the shin. Check the contact before adding effort; do not copy another person’s setting number.
  • Lower the thigh restraint onto the thighs above the knees until it holds them comfortably. It should not press onto the kneecaps. Check that the restraint, back-pad adjustment and roller adjustment are securely engaged.
  • Select a controllable resistance with the stack at rest. Take the intended handles on the thigh restraint and keep the torso supported. If you cannot work out how to release the restraint, ask staff before beginning the set.

How to do the movement

  1. Settle into the supported start

    Begin with the lower legs resting on the roller and the knees comfortably extended, without forcing them straight. Keep the hips on the seat and the thigh restraint comfortably in contact.

  2. Curl the roller down and back

    Bend the knees to move the roller down and back. Breathe out through the curl. Keep the thighs under the restraint and the hips supported. Pause briefly at a controlled endpoint, then return; do not lift or slide to take the roller farther.

  3. Guide the roller forwards

    Let the knees extend slowly to return towards the starting position. Maintain contact rather than allowing the resistance to throw the legs forwards. Keep breathing and control the turn into the next curl.

Finish and get out of position

  • Return the roller slowly until the resistance is at rest. Keep your legs supported and wait for the machine to stop before operating the restraint release.
  • Raise the thigh restraint using the model’s release, then move your legs clear of the roller and place your feet securely before standing. Keep fingers away from the restraint’s moving joint.
Exercise reference

Keep the key cue

Stop if a pad slips, an adjustment will not lock, or you feel sharp pain. The restraint should support you comfortably; it should not be painfully tight.

This browser keeps a reminder and link to the full tutorial.

Cues to remember

Knees near the pivot

The machine’s lever swings around its pivot while your lower legs swing around your knees. Back-pad position helps these movements line up; a higher resistance does not correct poor alignment.

Restraint on thighs, not kneecaps

The upper pad holds the thighs steady. If it blocks knee movement or presses painfully, return the machine to rest and reset it before continuing.

Hips stay seated

Watch for the bottom lifting or sliding forwards as the roller moves back. Use less resistance or stop the curl earlier if you cannot keep the supported position.

Is the leg curl the same movement as the leg extension?

No. In this seated curl, the roller supports the back of the lower leg and you bend the knees to move it down and back. In a leg extension, the roller sits in front of the shins and you straighten the knees. Check the machine label and pad position before starting.

What to watch out for

The thigh pad presses directly on the kneecaps.
Stop and reposition the restraint over the thighs, following the machine instructions. Tightening a painful pad is not a way to improve stability.
The hips lift to finish the curl.
Reduce the resistance or use a comfortable shorter curl while keeping the pelvis supported. Recheck the back pad and roller fit.
The roller snaps the legs forwards on the return.
Lower the resistance and practise returning slowly. Keep control until the machine rests rather than letting the stack drop.

Make it easier or build from this version

Record the back-pad, roller and restraint settings alongside resistance and repetitions. A heavier curl with a much shorter range is a different task, so note any change. A Romanian deadlift trains a different movement and is not an automatic progression from this seated knee-bending exercise.

Make it easier

Use a lighter stack setting

Keep the same supported seated curl and reduce resistance. Practise both bending and straightening the knees without the hips lifting.

Use a comfortable movement range

If the end of the curl makes you slide, finish earlier while keeping the pads properly positioned. An uncomfortable pad requires a setup check; do not compensate by forcing the movement.

Build from here

Add a controlled repetition as planned

Keep the same pad settings and range while adding a repetition within your existing programme. End the set before your hips start lifting to complete it.

Use the next appropriate load increment

Change the resistance only, then check that you can still guide the roller forwards as well as curl it back. Return to the previous setting if the new load pulls you out of position.

What can differ

Lying and standing leg curls place your body differently and have different entry, roller and support arrangements. A combined curl-and-extension machine may require changing its mode or start position. Follow that model’s instructions; this seated demonstration does not explain every conversion control.

Muscles involved

Main involvement

  • Back of the thighs (hamstrings). Bends the knees to draw the roller down and back.

Supporting involvement

  • Part of the calf (gastrocnemius). The part of the calf that crosses the back of the knee can assist with knee bending.
Explore these muscle regions in 3D

This optional anatomy view shows the named muscle locations. Use the real demonstration and written tutorial above for technique.

Sources and video credits

The demonstration is published by Life FitnessTraining and remains hosted by its publisher on YouTube.

SG Home Wellness provides the written tutorial using the sources below. Setup, finishing steps and modifications can extend beyond the clip. Controls on other equipment can differ.

The optional anatomy model has its own licence and attribution.

Coaching